Razors explainedWhat is a razor?
A cut throat razor has a single straight blade attached to a handle by a hinge and which is kept in the folded-edge first into a slot in the handle of the knife.
This method of shaving with a razor or cut throat razor is the most traditional and argued by some traditionalists as the only way razor shaving.
The straight-edge razor was also called the cut throat razor because it was dangerous enough to cut a man’s throat.
And in the civilizations of Greece and Rome used iron blades with a long handle and developed the form of cut throat ‘razor knife is the only practice until the 19th century With improvements in steelmaking came cut throat razor blades were really strong and able to be re-sharpened.
Advances in technology razor shaving habits changed in the 20th century In 1900, most men were clean-shaven local barber (trust confidante, wielding a knife cut throat), or periodically at home when necessary, rather than regularly. The Barber of customers better with staff of seven sets of cut throat razors, ‘Sunday’ a ‘Sabbath’. Today, almost all men shave every day in their own homes, using a wide variety of equipment.
Cut throat razor should be used with extreme caution. Executive shaving would be very happy to give advice on how to use the cut throat razor before purchase.
In general, the razor blades are made of steel, the most recent shaving razors have blades made of stainless steel. The maker of brands often find prints or prints on the sheets that can include the model.
The razor handles are made from all kinds of different materials, including wood, rubber, horn, ivory, bakelite, vegetable ivory and metal. Inlays and additions may be mother of pearl, silver, copper, ivory, wood, turtle.
Caring for your cut throat razor.
The razor must be properly looked after in order to garcontrazar maintenance and long life of this traditional men’s accessory. Although razors stainless steel are less demanding, other razors have to be rinsed with clear water and dry thoroughly after each use. When not in use for longer periods, it is recommended that the blade of the razor be rubbed with light oil. Likewise, the razor should not be stored in a damp and unaired state. There is no valid rule for the whetting (stropping) of straight razors, in many cases it is sufficient to draw the razor lightly over the ball of the thumb, especially when left unused for several days between shaves. Wet shavers old school knows that the facet (leaves) grows, ie, the discernible microscope and extremely fine fin at the forefront changes during shaving, but returns to its contragua position later, but and extends back becomes extremely thin. However, this fine fin still wear away at some point and suitable strop should be bought.
There is no general rule for sharpening Razors explained sometimes it is enough to hone in on the ball of the thumb, especially if the razor is not used for several days. People, who often use razors, know: the cutting edge is growing, which means that the very fine burr on the cutting edge (which can be seen under the microscope) changes whenever the razor is used, but ultimately it goes back to his contragua position and will become again very thin. However, the burrs are exhausted after a certain period of time and then the razor strop suitable must be purchased.
What should I do to whet the razor strop with?
While the leaves are flat whetted the suspension strop (velvet knives), Razors explained or Razors explained concave blades require a hanging strop made of fine cowhide leather or extremely supple Russia leather either a turning device for hanging or with hemp hose on the back, it used to align the fin in the direction pointing away from the knife. If necessary, the side Leather can be rubbed with a very thin thin layer of abrasive paste (red paste) and – for a final polishing on a strop – polishing paste (black paste), which worked with the ball of the thumb.
Stropping is performed at a fixed angle with the back of the razor strop set in, the knife pointing in the direction away from the body.
The knife is then delivered to the back and points to the body. Changing directions without turning the razor makes it to become the round blade (crowned) so that the court has been lost. In this case, only re-sharpening can help.
Razors are usually whetted in the factory for use (whetting on leather by hand). If you own a suitable strop, however, you should be aware that the razor first rest after use. After the razor has been carefully rinsed and dried, it must not be used again for at least 24-48 hours because the fine fin on the cutting edge straightens again very slowly. If the knife is too early stropped (or incorrectly stropped to move back and forth without resorting throughout), the end a close shave breaks is necessary. Between six and fifteen shaves are possible without stropping in between.
How they shave with a razor?
The beginner starts first with the smooth and trouble areas of the face. To do this, open the razor is held with thumb and three fingers so that the opened holder points away from the face. Good lathered with shaving soap and thus made supple, the skin should be stricter, the razor is moved at an angle of approx. 30 first in the direction of beard growth and then against the direction of growth. If held too flat, the razor rips the Razors explained if held too upright, it cuts the skin. Always move in the direction of the cutting edge and never horizontally (danger of injury); always call through uniform and hold a little more upright at corners, dimples and upper lip. If the knife are damaged when dropped or put in its holder, it should not be used further. Stropping not help here, the knife should be re-sharpened and whetted by a specialist.
Tips razor users.
In general, the best environment in which to store razors is well ventilated, dark, ambient temperature (72F or 20C), and not too dry or too humid.
It is convenient to conduct razors and liquid water outside as much as possible – both because the water will encourage the leaves iron rust, and also because water can cause serious damage to many material handling. Cleaning razors with bleach, ammonia or detergents are discouraged, as these substances can also cause damage.
Blade: Metal polishes like Brasso, Silvo, or Autosol should never be used in the blade of a razor. As well as damaging the surface, they may leave residues Polish unattractive, and can be detrimental to the blade and handle.
If the blade is dull or nicked, using a whetstone is recommended. A leather razor strop can be used to keep a big advantage. You know you’re getting close when you can slice a piece of paper with his knife.
Then clean the entire surface of the sheet with a Q-tip, moistened with either alcohol or ethyl alcohol. This will help to degrease the sheet razor. Then apply a thin layer of light mineral oil to the Razors explained let it sit for a short period of time (10 minutes or so) and then wipe off excess oil with a clean, dry cloth. This layer of oil help prevent any oxidation.
If you use your razor, use alcohol to remove oil before use, and again after use to clean the blade. Use mineral oil to re-oil the blade after use and after sharpening. Be careful not to get any alcohol or oil on the handle.